How To Light A Gas Fireplace Pilot. How much does it cost to replace the pilot light on a gas fireplace? Depending on how long it’s been since the gas fireplace was last used, ignition may take multiple attempts.
You may need to press the dial in to be able to turn it. The procedure commonly followed for lighting a gas fireplace with a dial and separate spark ignitor button can be: Keep a close eye on your pilot light once you have restored the flame.
Within The Controls, As Part Of The Ignition System, Will Be Your Pilot Light.
Continuously press the ignition button to generate the sparks until the pilot lights. First, turn your gas fireplace’s knob from the “off” to the “pilot” position. Once the pilot is lit, continue to hold the valve knob in for 60 seconds, then slowly release.
You Turn The Control Knob To The Pilot Position, Push The Knob In, Light The Pilot With A Match, Then Hold The Knob Down For 30 Seconds Or So Until The Pilot Stays Lit By Itself.
Press and hold down the gas control knob, then press the igniter button multiple times, as needed, until the pilot flame ignites. The pilot position is typically set on the control dial with either the dial depressed and turned, or used with a separate spark button to light the pilot flame. The pilot light in a gas fireplace is part of the pilot assembly.
The Dial May Need To Be Depressed To Allow Gas To The.
What is a gas fireplace pilot light? The main burner releases gas when the appliance is switched on, and the pilot light ignites the gas. How to light a gas fireplace pilot.
The Procedure Commonly Followed For Lighting A Gas Fireplace With A Dial And Separate Spark Ignitor Button Can Be:
Having some trouble with your gas fireplace? It uses a small amount of natural gas at all times, which means you do not need to use it often or wait for the system to warm up before turning on your fireplace. The steps involved in lighting your pilot on your gas fireplace include:
If The Pilot Does Not Light, Wait 5 Minutes And Try Again.
Once the pilot is lit, continue to hold the valve knob in for 60 seconds, then slowly release. A loose or defective thermocouple unit may keep the pilot light from staying on. This video will walk you step by step.